Table of contents:

Step-by-step assembly according to the origami dinosaur pattern
Step-by-step assembly according to the origami dinosaur pattern
Anonim

Adults and children love to collect a variety of origami paper figures. But without detailed instructions, it is easy to get confused, especially for beginners, in this type of needlework. The step-by-step diagram below is based on the Brachiosaurus paper dinosaur model, which can be completed by origami fans of any skill level.

What you need to build a dinosaur

Step-by-step recommendations for the origami dinosaur scheme will allow you to assemble a model in just 30 minutes. You will need the following materials:

  • paper;
  • ruler;
  • scissors;
  • glue to fix the finished product.

Figures made of colored paper look beautiful, it is worth giving preference to thicker sheets, painted on both sides.

Description of the step-by-step assembly of the dinosaur

First you need to prepare a paper square 20x20 cm. Then mark the folds as shown in the picture (steps 1-6).

Steps 1-6
Steps 1-6

After you get a figure resembling a rabbit ear, the corners must be folded withboth sides inward. The lower front flap rises up using the triangle formed by the marked pleats as a guide. Both sides are pressed towards the center, then you need to bend the resulting back flap (steps 7-8).

Next, turn the model over and fold the front. The bottom flap bends slightly as shown in the diagram of steps 9-10. This fold will help to mark a reference point for further assembly of origami.

Steps 7-10
Steps 7-10

The hardest part of the dinosaur circuit

The next stage is the most important, requiring special attention. Mistakes made in the origami dinosaur diagram in steps 11-19 will not allow you to complete the model to the end.

The edges need to be pressed against the folds obtained in step 10. The side flaps are folded up, and then the two large flaps are pulled down until they stop (steps 11-13). The folds need to be folded out and turned back on both sides (steps 14-15).

Steps 11-15
Steps 11-15

After that the model folds in half, the neck arches back. From the tip of the neck, with the help of several bends, a dinosaur head and the tip of the nose are formed. There are no criteria for the correct folding of the head. You can give it the shape you like. Optionally, you can also draw eyes, nostrils and mouth with colored markers (steps 16-18). After several folds, stable legs are formed (steps 19-20). The tip of the tail can be left straight or curved in several folds. And now a simple dinosaur figurine is ready.

Steps 16-20
Steps 16-20

Reduced toarticle paper dinosaur assembly scheme is suitable for anyone. A detailed step-by-step description with a schematic analysis will be clear even to beginners.

Recommended: