Table of contents:
2024 Author: Sierra Becker | [email protected]. Last modified: 2024-02-26 03:46
A plastic flower is a simple craft that can be made by hand without any problems. Most men don't think about it. But with the help of plastic surgery, you can make a wonderful craft that will become a symbol of your feelings for many years.
The most commonly used material for their creation is plastic from bottles. Recently, there are also crafts made from polymer clay with the addition of plastic. But so far they have not become widespread, and the creation of products in this case is much more complicated. Therefore, a plastic flower is usually made in the first way.
Tools
In the process of work, we need a set of the following materials:
- marker;
- scissors;
- pattern;
- ruler;
- knife;
- lighter or matches;
- awl.
In addition, glue, tape, paper (preferably with a bright and unusual pattern), wire, paint, heat shrink and plastic bottles of various sizes are useful. It is better to prepare all this in advance, so that later, in the process of creating such crafts as a plastic flower, you do not have to look for the right material ortool urgently.
Chamomile
The easiest way to make a camomile out of such containers. It is with her that we will begin our acquaintance with this craft. We take a container of any size. We make markings on its surface with a marker and cut it out either using a knife or scissors. Make a hole in the center of the workpiece with an awl. Next, you need to arrange the stem. To do this, take a piece of wire of the required length. For greater credibility, you can put heat shrink on it and heat it with matches or a lighter. An alternative option is to wrap with electrical tape or cover with paint. The first option is easier, so it's better to choose it.
From the rest we make leaves. From one of the edges we make a puncture with an awl. We wind the wire into this hole and fasten it to the stem. For more credibility, cover it with green paint. We put a camomile on one of the ends of the stem. We fix with glue and decorate. You can use bright paper or a set of paints. After decorating, the chamomile is ready. Any craft can be made from plastic. For flowers, this statement is more than true.
Rose
A little more difficult to make a rose from this material. The technology for creating the stem and its leaves is similar, we will not focus on it. But the rosebud is done as follows. We cut strips from the cylindrical part of the container. Their width should gradually increase. The smallest of them should be 2.5-3 cm. Further, it is recommended to increase them in increments of 0.5 cm. Then the edgethe widest strip is processed with a lighter or matches. At the same time, with the help of pliers, it bends to one side.
Then this blank is twisted in a spiral and fastened with wire or tape. At the next stage, we take that strip, which is a little narrower, and process its edge in the same way and twist it around the first part of the bud, which was made earlier. We do this operation until all the strips run out. At the final stage, we connect the bud and the stem. To do this, cut out a small cone from the rest of the bottle. We wind it around the bud and fix it with adhesive tape. We cut its other end and put it on the stem. We fix it with the help of the same adhesive tape. At the final stage, we decorate it. The plastic flower is ready.
Conclusion
It's not that hard to make a plastic flower. The master class held in the framework of this article confirms this. So let's go and do it. The result will surely exceed all your expectations!
Recommended:
How to weave a flower from rubber bands? Methods for making a flower pendant crocheted and on a loom
If you are wondering how to weave a flower out of rubber bands, try different ways, starting with the simplest ones. Lovely pendants can then be used as key rings or decorative details for fashionable Fanny Lum rubber band bracelets
Creative gift for March 8 with your own hands. Gift for mom on March 8
Do you think that all women still like only surprises that cost a lot of money? In fact, expensive underwear, diamonds, fur coats and cars are far from always able to deliver the same pleasure as a creative gift for March 8, made by oneself. After all, creating it, you invested in this gift not only your time and imagination, but also all your soul and love
A flower made of money is a universal gift
Each of us at least once wondered: “What to give a colleague (spouse, relative, friend, neighbor, leader)?” Since the times of total shortages are in the past, it has become easier to please loved ones with an excellent gift, and it is almost impossible to surprise them with something new and unusual. An original present - flowers from paper money, the manufacturing technology of which will be discussed
How to make a flower out of a plastic bottle
Flowers from plastic bottles for giving - an excellent decoration of the country landscape, they cheer up, they can be given to friends and relatives who have a plot, garden, front garden. It will be an unexpected and pleasant surprise for them. The article gives a small master class on how to make a flower from a plastic bottle quickly and easily
Let's talk about how to make a flower out of plastic bottles
Do-it-yourself products made from plastic bottles decorate many dwellings, summer cottages and garden plots. The thing is that plastic is inexpensive, it is constantly in wide availability, and most importantly, real masterpieces of arts and crafts are obtained from it. In this article we will talk about how you can make chic flowers from plastic bottles